Notes
•When using a two-speaker installation, the Green, Green/Black, Violet, Vio- let/Black wires, which are used for a four-speaker installation, are not used. The ends of these wires must be covered with electrical tape to prevent them from shorting to the unit or the vehicle chassis.
•When using a two-speaker installation, set the FADER control to the center position.
REPLACING THE FUSE
When fuse replacement is necessary remove the blown fuse by using pliers. Then install the new 10 amp. fuse.
LINE OUT CONNECTIONS
•The unit has a built-in CD changer controller and line out terminals. You can use a compatible Sanyo CD changer and a separate rear channel amplifier to upgrade your system.
RCA Line-out Jacks
White (Left)
Red (Right)
External Amplifier
CD Changer DIN Socket
Rear Speaker
CD Changer
CD Changer DIN Socket
•Connect the 8-pin DIN cable, which is supplied with the compatible Sanyo CD changer, to the DIN socket on the back of the unit.
RCA Line- out Jacks (For Rear Speakers)
•Connect a patch cable (not supplied) from the White (left rear channel) and Red (right rear channel) RCA line output jacks to the line input terminals of the external amplifier.
