STERILIZER COMPONENTS
1.Door: During use, inner panel of the door becomes extremely hot; Be careful.
2.Observation window: During use, glass and its surrounding become very hot; Be careful.
3.Leveling foot: Made of rubber. Can be adjusted by screws.
4.Fan (inside): Propeller type. To cool down the heat discharge plate and fan motor.
5.Control panel: Refer to page 9.
6.Separation plate: Do not place objects directly on the plate. Especially if the holes are covered, the proper temperature cannot be obtained.
7.Heater box (inside): The heater is attached under separation plate. The sirocco fan is also attached in this box.
8.Packing: Be careful not to scratch.
9.Key lock switch: Put the switch to "OFF" when you set the operating condition. After the setting, put the switch to "ON" to prevent the set condition from changing by accidental contact.
10.Main power switch with circuit breaker: Main switch for all power. When the operation of the unit is stopped by this circuit breaker, contact with a dealer or a service station after disconnected the power supply plug.
11.Exhaust air vents: The air inside the oven is exhausted from these vents. Be careful not to block these vents.
12.Handle: Pull the knob of inside of the handle to open the door.
13.Rack support: This can be adjusted to change the height.
14.Rack: They can be slid forward.
15.Exhaust air vent: The exhaust is controlled by opening/closing the vent. During use, the temperature of this section is extremely high; Be careful.
16.Temperature sensor (installation position): Be careful not to allow objects to touch the sensor or scratch it.
8
