Sanyo PDG-DSU30 owner manual Serial Control Interface, Operation

Appendices

Serial Control Interface

This projector provides a function to control and monitor the projector’s operations by using the RS-232C serial port.

Operation

1.Connect the specified RS-232C control cable to SERVICE PORT on the projector and serial port on the PC.

2.Launch a communication software provided with PC and setup the communication condition as follows:

3.Type the command for controlling the projector and then enter the “Enter” key.

Example

When you want to change the input to Computer, Type ‘C’ ‘0’ ‘5’ ‘Enter’.

Baud rate	: 9600 bps
Parity check:	: none
Stop bit	: 1
Flow control	: none
Data bit	: 8

Note

•The default of the baud rate is set to 9600 bps. If an error occurs in the com- munication, change the serial port.

•Enter with ASCII 64-byte capital characters and one-byte characters.

ORDER RS-232C CONTROL CABLE

RS-232C control cable can be ordered through your dealer. When order- ing, give the following information to the dealer.

■Model No. of your projector : PDG-DSU30

■RS-232C control cable : Service parts No. CH4200272G002

46

English