SETTING
On start
When this function is “On” the projector is automatically turned on just by switching the MAIN ON / OFF SWITCH on.
NOTE: Be sure to turn the projector off properly (refer to the section “TURNING OFF THE PROJECTOR” on page 23). If the projector is turned off in the wrong steps, the On Start function does not operate properly.
Lamp Mode
This Projector is equipped with 4 Projection Lamps and the number of using lamps can be switched to 4 lamps or 2 lamps. Using 2 lamps maintains the life of the Projection Lamps.
To change over Lamp Mode
1.Press the MENU button the
2.Press the POINT DOWN button and move a
NOTE : After changing Lamp Mode, it cannot be switched again for 90 seconds.
USB
This Projector is equipped with USB port for interactive operation between the projector and the computer. Set the mode following steps below.
Wireless Mouse mode
Select " " when controlling the computer with the Remote Control of this projector.
Projector mode
Select " " when controlling the projector with the computer.
NOTE: Before you control the projector by computer, install USB driver (optionally sold parts) and set up the computer following instruction in the USB driver package. Contact your authorized dealer.
Remote control
This projector has two different remote transmit codes; the
When operating the projector in “Mode 2” both projector and Remote Control must be switched to “Mode 2”.
To change the code of the projector;
Set the Remote control in the SETTING menu to “Mode 2”.
To change the code of the Remote Control;
Press both the MENU and the NORMAL buttons on the Remote Control together for over 10 seconds.
After changing the code, make sure the Remote Control operates properly.
To return to the normal code (Mode 1), operate both projector and Remote Control in the ways above again.
NOTE: When the
40