Sanyo PLC-XF20 manual SERVICE

APPENDIX

Problem:	Try these Solutions:
Picture is L/R Reversed.	Check Ceiling/Rear feature.
	(See "SETTING" section on page 39).
Picture is T/B inverted.	Check Ceiling feature.
	(See "SETTING" section on page 39).
Some displays are not seen	Check Display feature.
during the operation.	(See "SETTING" section on page 39).
No sound.	● Check audio cable connection from audio input source.
	● Adjust audio source.
	● Press the VOLUME (+) button.
	● Press the MUTE button.
Remote control unit does not	● Check the batteries.
work.	● Make sure nothing is blocking between the remote control sensor and remote
	control unit.
	● Make sure you are not too far from the projector when using the remote
	control unit. Maximum operate range 16.4 ' (5 m).
	● Check the ALL-OFF switch on the Remote Control Unit is set to "ON".
	● Check the transmitted signal mode from the remote control unit.
	(See "SETTING" section on page 39, 40).
Wireless mouse function	● Check the cable connection between the projector and the computer.
	● Check the mouse setting on your computer.
does not work.
	● Turn on the projector before you turn on the computer.

SERVICE

WARNING: High voltages are used to operate this projector. Do not attempt to open the cabinet.

You can often correct operating problems yourself. If the projector fails to work properly, see "TROUBLESHOOTING" section on page 46, 47. To correct the failure, try the "Solutions".

If after following all operating instructions, you find that service is necessary, contact the Sanyo Service Station or the store where you purchased the unit.

Give the model number and explain the difficulty. We will advise you how to obtain service.

This symbol on the nameplate means the product is Listed by Underwriters Laboratories Inc. It is designed and manufactured to meet rigid U.L. safety standards against risk of fire, casualty and electrical hazards.

The CE Mark is a Directive conformity mark of the European

Community (EC).

47