APPENDIX

LAMP REPLACEMENT

When the projection lamp of this projector reaches its

end of life, the LAMP REPLACE indicator lights yellow. If

this indicator lights yellow, replace the projection lampTOP CONTROL with a new one promptly.

This indicator lights yellow when the projection lamp reaches its end of life.

Replace the projection lamp with a new one promptly.

CAUTION

Allow the projector to cool for at least 45 minutes before you open the lamp cover. The inside of the projector can become very hot.

CAUTION

For continued safety, replace with a lamp assembly of the same type.

Do not drop the lamp assembly or touch a glass bulb! The glass can shatter and may cause injury.

Follow these steps to replace lamp assembly.

1

Turn off the projector and unplug the AC power cord.

 

Allow the projector to cool for at least 45 minutes.

2

Loosen the two (2) screws with a screwdriver and open

 

the lamp cover.

3

Loosen the two (2) screws with a screwdriver and pull out

 

the lamp assembly by using the built in handle.

4

Replace the lamp assembly with a new one and tighten

 

the two (2) screws. Make sure that the lamp assembly is

 

set properly. Put back the lamp cover and tighten the two

 

(2) screws.

5

Connect the AC power cord to the projector and turn on

 

the projector.

6

Reset the Lamp replacement counter (refer to”LAMP

 

REPLACE COUNTER” on the next page).

NOTE:

Do not reset the Lamp replacement counter when the projection lamp is not replaced.

 

LAMP COVER

LAMP

HANDLE

ASSEMBLY

 

ORDER REPLACEMENT LAMP

Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following information to the dealer.

Model No. of your projector

:

PLC-XP57L

Replacement Lamp Type No.

:

POA-LMP101

 

 

 

(Service Parts No. 610 328 7362)

48

Page 48
Image 48
Sanyo PLC-XP57L owner manual Lamp Replacement, Order Replacement Lamp, POA-LMP101