Setting
47
Remote control
This pro jector provides two differen t remot e cont rol
codes: the factory-set initial code (Code 1) and the
secondary code (Code 2). This switching function
prevents remote control interference when operating
several projectors or video equipment at the same
time.
When ope rating the p rojector in "Code 2", bo th the
projector and the remote control must be switched to
"Code 2".
To change the code for the projector:
Select either "Code 1" or "Code 2" in this Setting Menu.
To change the code for the remote control:
Press and hold both th e MENU and I MAGE butt ons
together for 5 seconds or more. After changing the
code, make sure the remote control operates properly.
Remote control
Press and hold
MENU and
IMAGE buttons
for more than 5
seconds.
Setting
On start
When this function is "On", the projector is
automatically turned on just by connecting the AC
power cord to a wall outlet.
✔ Note:
Be sure to turn the projector off properly (see
"Turning Off the Projector" on page 19). If the
projector is turned off in the incorrect sequence,
the On start function does not operate properly.
Lamp control
This function allows you to change brightness of the
screen.
Normal. . . . . normal brightness
Auto. . . . . . . bri ght ness ac cor ding w ith the
input signal
Eco . . . . . . . lower brightness reduces the lamp
power consumption and extends
the lamp life.
On start