Sanyo PLC-XW56 owner manual Lamp Handling Precautions, Lamp Replacement Counter

Maintenance and Cleaning

Lamp Replacement Counter

Be sure to reset the Lamp replacement counter after the lamp is replaced. When the Lamp replacement counter is reset, the LAMP REPLACE indicator stops lighting.

1	Turn the projector on, press the MENU button to
	display the On-Screen Menu. Press the Point ◄
	► buttons to move the red framed pointer to the
	Setting Menu icon.
2	Press the Point ▲▼ buttons to move the red	To reset the lamp counter,
	framed pointer to the Lamp counter function and
	then press the SELECT button. A dialog box	move the pointer to
	appears showing the total accumulated lamp hours	Reset and then press the
		SELECT button. “Lamp
	and reset option. If you select "Reset", a "Lamp
		replacement counter
	replacement counter Reset?" message appears.	Reset?” dialog box is
	Select [Yes] to continue.	displayed.
3	Another confirmation dialog box appears, select	Select [Yes],
	[Yes] to reset the Lamp replacement counter.	then another
		confirmation
 Note:		box appears.

Do not reset the Lamp replacement counter
	Select [Yes] again
without implementing lamp replacement. Be sure
	to reset the lamp
to reset the Lamp replacement counter only after
	counter.
replacing the lamp.

LAMP HANDLING PRECAUTIONS

This projector uses a high-pressure lamp which must be handled carefully and properly.

Improper handling may result in accidents, injury, or create a fire hazard.

●Lamp life may differ from lamp to lamp and according to the environment of use. There is no guarantee of the same life for each lamp. Some lamps may fail or terminate their life in a shorter period of time than other similar lamps.

●If the projector indicates that the lamp should be replaced, i.e., if the LAMP REPLACE indicator lights up, replace the lamp with a new one IMMEDIATELY after the projector has cooled down. (Follow carefully the instructions in the Lamp Replacement section of this manual.) Continuous use of the lamp with the LAMP REPLACE indicator lighted may increase the risk of lamp explosion.

●A Lamp may explode as a result of vibration, shock or degradation as a result of hours of use as its lifetime draws to an end. Risk of explosion may differ according to the environment or conditions in which the projector and lamp are being used.

IF A LAMP EXPLODES, THE FOLLOWING SAFETY PRECAUTIONS SHOULD BE TAKEN..

If a lamp explodes, disconnect the projector's AC plug from the AC outlet immediately. Contact an authorized service station for a checkup of the unit and replacement of the lamp. Additionally, check carefully to ensure that there are no broken shards or pieces of glass around the projector or coming out from the cooling air circulation holes. Any broken shards found should be cleaned up carefully. No one should check the inside of the projector except those who are authorized trained technicians and who are familiar with projector service. Inappropriate attempts to service the unit by anyone, especially those who are not appropriately trained to do so, may result in an accident or injury caused by pieces of broken glass.

55