52
WARNING:High voltages are used to operate this projector. Do not attempt to open the cabinet.
If problems still persist after following all operating instructions, contact the dealer where you purchased the projector or
service center. Give the model number and explain about the problem. We will advise you how to obtain service.
–Solutions Problem:
LOGObutton doesnotwork. –Check the Logo setting. Make sure Logo is not set to off. (see page 40).
Theexclamation markappearson
the screen.
–Your operation is invalid. Operate correctly.
Appendix
TheRemote Controldoesnot work. –Check the batteries.
–Make sure there is no obstruction between the projector and remote control.
–Make sure you are not too far from the projector when using the remote control.
Maximum operating range is 16.4’ (5 m).
–Make sure the code of the remote control is conformed to that of the projector (see
page 41).
Horizontalline noiseoccurs. –When connecting HDTV equipment to the projector’s COMPONENT 1/2 terminals,
horizontal line noise may be noted only occasionally. Then adjust the value of Fine
sync. (see page 34).
Imagedisappears automatically. –Check the power mamagement function in the Setting. The power management is
set to “On” at the factory (see page 41).
Powermanagement doesnotwork. – When “Freeze (p. 23),” “No show (p.23),” “Cleaning (p.42),” or “Test pattern (p.42)”
are operating or Logo is displayed, the power management function cannot be
operated (see page 41).
Imageis Left/Rightreversed.
Imageis Top/Bottomreversed.
–Check the Ceilng/Rear item (see page 37).
–Check the Ceiling item (see page 37).
Theedge oftheimage isdistorted. –With maximum lens shift, image distortion may be observed (see page 14).
Autoadj. doesnotwork. –The Auto adj. function cannot be operated with the video input, some incompatible
computer input and digital signals (see page 34).
Imageis distortedorruns off. –Check “Picture adj.” menu or “Screen”menu and adjust them.
Somedisplays arenotseen
duringoperations.
–Check the Display item (see page 40).
Thesetting doesnotremain after
turningoff power.
–Make sure you selected “Store” after adjusting settings. Some settings cannot be
sotred if not registered with “Store.”
Switchingbetween HDMI1and
HDMI2 takes time.
–When switching from HDMI 1 to HDMI 2 or vice versa, the signal may be
interrupted for a moment depending on the equipment (see page 26).
Somemenus cannotbeselected. –Check the connection to see if there is signal. “Image,” “Image adj.,” “Picture adj.,”
and “Screen” cannot be selected without an input signal.
Capturefunction doesnotwork. –Check the connection to see if there is signal.
Imagedoes notappearwith HDMI1
orHDMI 2.
–Turn on the Video equipment again.
–Check the connection of cables.
RESETbutton doesnotwork. – This function is limited to when selecting the Image Adjustment Menu and Picture
Adjustment Menu (see page 22).
Abnormalnoise isdetectedduring
projection.
–Motor noise or shutter noise can be heard when selecting or switching “Image,” or
projecting an image with the large brightness fluctuation.
Indicatorsblinks orlights. –Check the status of the projector with referring to “Indicators and Projector
Condition” (see page 53).
http://www.pureglare.com.au