Sanyo PLV-Z2000 Rear Terminal

DCOMPUTER

Connect the computer output signal, or RGB Scart 21-pin

video output to this connector (p.16).

Rear Terminal

D J

LVIDEO

Connect the composite video output signal from video

equipment to this jack (p.15).

8COMPONENT 1 or COMPONENT 2

Connect the component video output signal to these jacks

(p.15).

JS-VIDEO

Connect the S-Video output signal from video equipment

to this jack (p.15).

ESERVICE PORT

This jack is used to service the projector.

GHDMI 1/HDMI 2*

Connect the HDMI output signal from video equipment

to these terminals (p.16).

*Note on the HDMI connector:

Use the HDMI connector less than the size shown below.

Otherwise you cannot connect use HDMI 1 and HDMI 2

terminals at the same time.

0.94" (24 mm) 0.59" (15 mm)

WIDTH THICKNESS

Maximum dimensions of the HDMI connectors

Part Names and Functions

http://www.pureglare.com.au

Contents

Main XLens Shift XColor Management XAuto Iris XCompatibility Features and Design Table of Contents CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN Safety Precaution To the Owner CAUTION Voor de klanten in Nederland NL Safety Instructions Moving the Projector NO DOWNWARD NO SIDEWARD Installingthe Projector in Proper Position Air Circulation CAUTION Compliance Bottom Back @ Front Part Names and Functions Rear Terminal TopControl Remote Control Remote Control Operating Range Remote Control Battery Installation 40 Adjustable Feet Positioning the Projector Installation Moving the Lens Connecting to Video Equipment (Component) Connecting to Video Equipment (Video, S-Video) Connecting to a Computer Connecting to Video Equipment (HDMI, RGB Scart) CAUTION Connecting the AC Power Cord For the U.S.A. and Canada For Continental Europe NOTE ON THE POWER CORD Projector side AC Outlet side Basic Operation 2 TurningOff the Projector How to Operate the On-Screen Menu Menu and its Functions LIGHT button Remote Control Operation Zoom and Focus Adjustment RESET button SCREEN button BACK button IMAGE ADJ. button BRIGHTNESS button FREEZE button CONTRAST button COLOR button Input Video or S-Video Component 1 or Component 2 Menu Operation 3 4 5 6 Input HDMI 1 or HDMI 2 Computer 2 Image Mode Selection Image 2 3 Image Adjustment Image Mode Adjustment Page Page Page COLOR MANAGEMENT Page 1 2 Picture Position and Screen Adjustment 3 Picture Adjustment 2 Screen Size Adjustment Screen Screen List of the projected images Setting Page Page Page To change the code of the projector: To change the code of the remote control: Page Input Source Information Display Information TOP CONTROL Warning Indicator TOP CONTROL Maintenance and Cleaning Cleaning the RGB panels If the nozzle is pulled out .... Clean by using the Cleaning function in the Setting Menu RECOMMENDATION Cleaning the Air Filter Reset the filter counter(p.48). Resetting the Filter Counter Filter counter Cleaning the Projection Lens Cleaning the Projector Cabinet ORDER REPLACEMENT LAMP CAUTION 6 Lamp Replacement CAUTION LAMP HANDLING PRECAUTIONS IF A LAMP EXPLODES, THE FOLLOWING SAFETY PRECAUTIONS SHOULD BE TAKEN. Resetting the Lamp Replacement Counter Troubleshooting Solutions Problem: Appendix WARNING: High voltages are used to operate this projector. Do not attempt to open the cabinet. Solutions Problem: Indicators and Projector Condition Projector Condition Indicators Menu Tree Image Image adj. Input theselected image mode. Screen Picture adj. Setting Information System Mode Chart TechnicalSpecifications Optional Parts Pin Configuration OHDMI Cable Type No.: POA-CA-HDMI (This cable is used for RGB Scart 21-Pin Video output of video equipment.) Configurations of Terminals Dimensions Unit: inch (mm)