Sanyo POA-LN01 appendix Connection of LAN cable

Models: POA-LN01

1 52
Download 52 pages 37.31 Kb
Page 12
Image 12
[2] Connection of LAN cable

Installation

[2] Connection of LAN cable

To connect to the network, it is required to use the UTP (Unshielded Twisted Pair) straight cable with RJ-45 plug. There are two different types of cables depending on whether the network is constructed with 10Base-T or 100Base-TX. Prepare the Hub (10Base-T or 100Base-TX) to distribute the network cable.

1 Disconnect the AC plug from the monitor.

2 Connect the UTP straight cable to the LAN port on the network board.

3Connect the UTP straight cable to the hub.

The AC cord must be disconnected from AC power outlet when connecting the cable. It may dam- age the product.

Use the UTP cross cable when you connect the computer and monitor directly not using the hub.

When you connect the monitor into the 10Base-T network, use cable with category 3 or 5. When you connect the monitor into the 100Base-TX network, use cable with category 5.

The length of cable between hub and monitor should be less than 100m.

12

Page 12
Image 12
Sanyo POA-LN01 appendix Connection of LAN cable