Sanyo POA-LN01 Network configuration, Procedure of Connecting the monitor to the network, 14-19

Network configuration

[3] Network configuration

When you connect a monitor to a network, the network number of monitor must be the same as the network you intend to connect. You should configure monitorʼs network first. Make sure that the monitor is connected to the network correctly. To configure the network, use the computer. Refer to the chart below.

Procedure of Connecting the monitor to the network

Configure the network with computer		p.14
Temporarily set up the computer's	Please see further
	informatin on pages
network with the default network	14-19.
number of the PJ-Net Organizer.	Example of monitor's configuration
	IP Address : 192.168.0.5
	Subnet Mask : 255.255.255.0
Restart the Computer, if required	Default Gateway : (blank)
	DNS : (blank)
Using the web browser and login to	Please see further
the setting page of the PJ-Net	informatin on pages
Organizer by accessing the default	22-25.
IP address.	Default Network Address of the PJ-
	NetOrganizer
	IP Address : 192.168.0.2
	Subnet Mask : 255.255.255.0
	Default Gateway : 0.0.0.0
Change the network address you	DNS : 0.0.0.0
want to connect to the existing
network through the setting menu	Example of monitor's configuration
on the browser.	IP Address : 172.21.95.224
	Subnet Mask : 255.255.255.0
	Default Gateway :172.021.095.001
	DNS : 172.21.1.53

Restart the PJ-Net Organizer

Reset to the computer's original network configuration.

Completing the network configuration. Perform the basic setting and operation of the monitor by using the web browser. Please see chapter "2: Basic Setting and Operation" on page 21 for further information.

13