Configure the network with the computer, Dns | Sanyo POA-LN01

Installation

Configure the network with the computer

This example explains how to set the following configuration.

IP Address	: 172.21.95.224
Subnet Mask	: 255.255.255.0
Default Gateway	: 172.21.95.1
DNS	: 172.21.1.53

The default network configuration is set as follows.

IP Address	: 192.168.0.2
Subnet Mask	: 255.255.255.0
Default Gateway	: 0.0.0.0
DNS	: 0.0.0.0

Make sure that the monitor is connected to the network and then connect the AC cord to the outlet.

1 Temporarily*1 set up your computer network configuration to the same IP network num- ber as the PJ-Net Organizer. For example, change your computer network configura- tion as follows and restart the computer.

IP Address	: 192.168.0.5
Subnet Mask	: 255.255.255.0
Default Gateway	: (blank)
DNS	: (blank)

The network configuration of computer differs depending on each network environment or your computer. For further information, please see the chapter “Configure the network of computer” on page 17.

*1 Change your computerʼs network configuration temporarily. After completing the set up for the mon- itor, you must set up again to the original network configuration for your computer. It is recommend- ed to make a note of those network settings.

14

Image 14

Sanyo POA-LN01 appendix Configure the network with the computer, Dns

Contents

PJ-Net Organizer OWNERʼS Manual Federal Communication Commission Notice PreparationCompliance Trademark Expression/Abbreviation Use of this manual Contents Mail Alert function FeaturesWeb Management function Recommended Operating Environment Installation Installation p.10-12 InstallationFlow of installation Network configuration p.13-19 Name and function of each part LCD Monitor Mounting Up Down Position Position Connection of LAN cable Network configuration Procedure of Connecting the monitor to the network Configure the network with the computer DNS Completing of installation Flash Player Configure the network of computer Windows Windows XP Installation Page Basic Setting and Operation Login Basic Setting and OperationLogin the setting page of the monitor Enter the IP address Display of setting Initial Settings Password Setting Configure the network Setting the model ID Administrator Address Mail SettingMail Setting Smtp Server*1 Mail Check and Delete Option Condition selection for sending alert message Examples Type and contents of alert mail Trap Send Setting Trap Snmp SettingLCD Information Setting Snmp Agent Trap Check and Delete Trap Option Selection for sending alert message Controlling the Monitor Status Controlling the MonitorCheck the status of monitor Child Lock Key Lock of Monitor Power Control the monitor Wide Mode Input Other Use other command Make a memoPage Serial Port Use Example of Connection Specification and Setting of RS232C TerminalSerial Port Use Command for controlling the monitor Example Power on C00 How to set Network configuration on network board to default Appendix Direct connection AppendixExamples of Connection Gateway Router installed in the network Meeting Room Proxy setting Web browser settingActive Script/JavaScript enable Windows XP Professional Internet Explorer ActiveScript settingExamples OS/Browsers Not using proxy server Proxy settingUsing proxy server Product specification Applicable monitor model Pin modular connector RJ-45 Port SpecificationLAN port specification MAC AddressPage Part No 333 5582 1AA6P1P5387-- Iffna