Installation
[1] Mounting
1 Disconnect the AC plug from the projector.
2 Remove all of the hole covers (3 round type, 4 square type) on the rear of the projector and insert plug on this product to the DVI connector.
Mount as the SW lever on the Unit presses the mount detecting SW on the projector.
3 Tighten three screws by using a | Mount detecting SW |
coin etc. | hole covers |
Note:
This network unit is connected to the DVI terminal on the projector, therefore, the digital input does not be used when this unit is mounted. The analog input of the Computer 2 can be used through the VGA terminal on the network unit.
*Please use a VGA cable supplied with your projector.
VGA cable
From computer
!Caution
✐The AC cord must be disconnected from AC power outlet when mounting or removing this product. It may damage the product.
✐Do not connect the AC cord until after connecting the LAN cable and computer.
12