Power on/off the projector
Check the status of projector
In the "Power & Status" page, you can control the projector power, and also you can check the status of the projector as follows:
Items | Description | ||||||
Accumulated | It displays in 1 hour units (h) | ||||||
| When resetting the lamp counter, this time will be reset to 0. | ||||||
Accumulated | It displays the accumulated used time in an hour unit (h). This | ||||||
| cannot be reset. | ||||||
Power status | It displays the status of the lamp, OFF, On starting up, ON, On | ||||||
| cooling down. | ||||||
Projector condition | It displays the condition of the projector's power, Normal, | ||||||
| Power Failure, Temperature Error, Normal after temperature | ||||||
| over, On Power management working. | ||||||
Input status | It displays the selected input mode, signal mode and signal | ||||||
| status. | ||||||
Internal temperature | It displays the temperature at internal thermal sensors in | ||||||
| degrees. The icons [A], [B] and [C] on the page represent the | ||||||
| thermal sensors located in the projector. If the temperature at | ||||||
| one of those sensors exceeds specified temperature, the | ||||||
| appearance of its icon changes to the following alert icon to let | ||||||
| users know about the abnormal temperature. Please check | ||||||
| surrounding temperature of the projector, check for clogged air | ||||||
| filters and check area surrounding the ventilation fans. | ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
The icons [A], [B] and [C] represent the sensors located in the projector as follows:
[A]: Surrounding temperature of the projector *
[B]: Surrounding temperature of the lamp
[C]: Surrounding temperature of the panels
*The indicated peripheral temperature of the projector is a little higher than actual surrounding temperature.
Network Unit
OWNER’S MANUAL
ENGLISH
37