Network configuration

How to enter the numbers

To move the selection and change the values, Use the pointers ▲/▼/7/8 on the projector or on the remote control handset.

The 7/8 keys are used to move the selection item. The ▲/ ▼ keys are used to change the number value.

3 Restart the Network Unit

Select the SET with the 7/8 keys and press the SELECT button again. The network configuration display disappears and the Network Unit begins restarting*1. It takes about 60 seconds. Do not disconnect the AC cord from the projector.

Completing of installation

Now the installation is completed. The IP address of this projector was set to “192.168.1.201”. Next, please see chapter “Basic setting and operation” on page 25. It describes basic setup and operation of the projector.

Password setting menu [Display]

A password can be set to restrict access to the setting pages of the projector using the web browser. The default password is set “0000” as no password.

Use the projector’s menu and select the Display icon on the Setting sub menu, and then press the SELECT button on the projector twice. The following setting display appears on the screen. The numbers on the display indicates the current password. To change the password, enter your desired number by using the pointers on the projector or remote control handset, and then select the SET with the 7/8 keys and press the SELECT button. The password setting display disappears and the Network Unit begins restarting*1. It takes about 60 seconds. Do not disconnect the AC cord from the projector.

Password

 

 

0

0

0

0

SET CANCEL

*1 The Network Unit begins restarting automatically when the network configuration or password setting is changed. After the power indicator turns off twice, and it lights continuously. This indicates that restarting is completed and it takes about 60 seconds.

✐Password setting must be done when you connect the projector to the network. This setting is carried out through the projector’s menu and also it can be set through the network using the web browser. For further information please refer to chapter “Initial Setting/Password setting” on page 29.

✐Valid characters for password are only numeric numbers 0 to 9.

✐This password is not to restrict the use of the projector. This password is to set the security against the use of the projector through the network.

Network Unit

OWNER’S MANUAL

ENGLISH

17