INSTALLATION INSTRUCTIONS
■Parts included in the package
See Table 1.
Table 1
Parts | Figure | Q'ty | Parts |
|
| Figure | Q'ty | Parts | Figure | Q'ty |
|
|
|
|
|
|
|
| |||
|
|
| Tapping | 5/32 | 13/32" | 1 | Clamping |
| 1 | |
|
|
| (4 | 10mm) |
| |||||
|
|
| screw | strap |
| |||||
|
|
|
|
|
|
|
|
| ||
Wire |
|
|
|
|
|
|
|
|
|
|
(with a |
| 1 |
|
|
|
|
|
|
| |
noise filter) |
|
|
|
|
|
|
|
|
| |
|
|
| Clamp |
|
|
| 2 | Wire tube |
| 1 |
Installation |
|
| Label |
|
|
| 1 |
|
| Top cover |
| 1 |
|
|
|
|
|
| |||
instructions |
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
| |
■Installing the connection kit
A. 7000 BTU, 9000 BTU, and 12000 BTU inverter models
(1)Remove the air intake grille.
(2)Remove the terminal cover. Pull out the thermistor, then remove the grille.
•For details on steps (1) and (2), refer to the Installation Instructions included in the outdoor unit package.
Tab | Screw |
Screw |
(3)Disengage the top cover from the tabs on the sides of the component box, then pull the cover toward you to remove it. (Fig. 1)
(To disengage the tabs, pull the sides of the top cover sideways and out- ward from the component box.)
Component box |
(4)Remove the 4 component box installation screws. (Fig. 1)
(5)Disconnect the
(6)After removing the wires, insert Connector 1 of the wires (Fig. 3a) that were included in the kit package into the indicator (Fig. 2a), then insert Connector 2 into the component box. (Fig. 2b)
At this time, pass the wires through so that they are held inside the 2 holders on the sides of the component box.
(Fig. 3b)
Connector (10P)
Indicator 
Fig. 2a
Connector 2
Connector 3(10P)
(4P)
Noise filter
Connector 1
(10P)
Fig. 3a
Fig. 1
P.C. board
Connector (10P)
Fig. 2b
Holder
Fig. 3b
| SANYO Commercial Solutions | In Canada |
| A Division of SANYO North America Corporation | SANYO Canada Inc. |
85264190491000 © SANYO 2009 | 1300 Michael Drive, Suite A | |
Wood Dale, IL 60191, U.S.A. | Ontario, L4K 5C7, Canada | |
|
| W |
