OUTPUT TERMINALSREMOTE Jack
You can use a VA-RMN01 Remote Control Unit (sold
separately) to control remotely the VCR.
NOTE:
XThe functions not available on the VCR will not operate.
Remote control of the VCR is possible by connecting a
remote controller with a circuit such as indicated below, to
the REMOTE jack.
NOTES:
XUse a 3.5 mm mini-jack type plug.
XThe connection should be done using a shielded cable
no more than 5 meters long.
XThe functions not available on the VCR will not operate.
Remote control setting
The remote control switch 7 can be set to either eject the
tape or access the menus.
1Press the MENU button until the (SET UP 1) menu is
displayed.
@@@@@@@<SET@UP@1>
*DAYLIGHT@SET@@@@@USE
@@@@@@@@WEEK@MONTH@TIME
@ON@@@1ST-SUN@@04@02:00
@OFF@@LST-SUN@@10@02:00
*CLOCK@SET
@10-15-01@MON@@15:20:00
*REMOTE@@@@@@@@EJECT
*LANGUAGE-LANGUE-IDIOMA
@@@ENGLISH
2Press the * (or +) button, until the “REMOTE” setting
is flashing.
3Press the l (or j) button to select the desired switch
mode.
EJECT . . . . . Switch 7 will eject the tape.
MENU. . . . . . Switch 7 will display the menu.
4Press the SEARCH/AUDIO ON button to save the
setting.
WARNING OUT Terminal
XIf the tape stops or other problem, the output becomes
0V (Low).
XTo reset the output, press the STOP or ALL RESET
button or unplug the power cord then plug it back in.
NOTE:
XIf the output is 0V (Low) due to the clog detect function,
it can be reset by simply pressing the STOP button.
COM Terminal
XCommon GND (ground) terminal when connecting
other terminals to external devices.
SW0: EJECT
R0 1.2K
Remote control circuit
The resistance tolerance is
2% or less.
SW2: STILL/PAUSE
SW3: REW
SW4: FF
SW5: PLAY
SW6: REC
SW7: EJECT (or MENU)
SW8: REV
SW1: STOP
SW9: REC/PLAY SPEED j, j
SW10: REC/PLAY SPEED l, l
SW11: SHIFT ], »
SW12: SHIFT «, «
R2 0.43K
R3 0.51K
R4 0.62K
R5 0.75K
R6 0.91K
R7 1.1K
R8 1.3K
R1 0.3K
R9 2.0K
R10 2.4K
R11 3.6K
R12 5.6K
Tape movement stop
5V (H)
0V (L)
(Output impedance: 5.7 kΩ)
Output reset
RC4Q/NA2 (TLS-9072 GB) Thu. Sept., 07/2000
34 English