NORMAL RECORDING

Normal Recording

Before starting

XTurn the power on to all devices used.
XLoad a cassette tape with erasure-prevention tab.
NOTE:
XIf in the (SET UP 3) menu, TAPE IN MODE is set
to “REC”, recording will start after the tape thread
has been checked.
XSet the ON SCREEN switch to the “ON” position.
1Press the REC/PLAY SPEED l (or j) button to set
the recording speed mode.
ø
The recording speed mode is displayedon-screen and on the digital display.
2Press the REC button.
ø
The record indicator
“m”
light.
ø
Recording starts.
ø
If the tape end is reached while recording, “OFF”is displayed on the digital display and the unitgoes into the mode set at the “TAPE ENDMODE” line in the (SET UP 3) menu.
NOTES:
XIf in the (SET UP 2) menu, in the BUZZER section
TAPE END is set to “Y”, the buzzer will be heard
as long as “OFF” is displayed on the digital display.
XTo cancel the “OFF” display, press the STOP,
EJECT, FF, REW or PLAY button.
3To stop recording, press the STOP button.
NOTES:
XA tape recording made on this VCR may not play back
with the same degree of clarity on a time lapse from
another manufacturer.
XIf you press on the REC button and the loaded
cassette has no erasure-prevention tab, the VCR will
eject the cassette.
[Recording Speed Mode]
Recording
speed mode
(hour mode)
Maximum
recording
duration (hours)
Recording
interval
(second) Audio recording Tape motion
2 21/60
Possible Continuous12 14 7/60
24 26 13/60
48 50 25/60 Not possible Intermittent
72 74 37/60

Record Pause

Recording can be interrupted temporarily.
1Press the STILL/PAUSE button during recording.
ø
The Pause/Still indicator
“N”
blinks.
NOTES:
XThe image appears on-screen but it is not recorded.
XIf a recording pause continues for 5 minutes or
more, the VCR will go into stop mode to avoid
damaging the tape.
2To resume recording, press the REC button, or press
the STILL/PAUSE button again.
RC4Q/NA2 (TLS-9072 GB) Thu. Sept., 07/2000
16 English