OUTPUT TERMINALS

TAPE END OUT Terminal

XDuring recording, when the end of the tape is reached
or when the tape counter reading indicates 1 hours 57
minutes or more, the output becomes 0V (Low).
XTo reset the output, press the STOP or EJECT button.
XDuring autorepeat recording, when the end of the tape
is reached, the output becomes 0V (Low) for about 2
seconds only.
TAPE END OUT Terminal Output Setting
1Press the MENU button until the (SET UP 3) menu is
displayed.
@@@@@@@<SET@UP@3>
*ALARM@MODE@@@@@@@Y1
*ALARM@DURATION@@@20S
*TAPE@IN@MODE@@@@@STOP
*TAPE@END@MODE@@@@REW
*TAPE@END@OUT@@@@@-3M
*CLOG@DETECT.@@@@@Y
2Press the * (or +) button, until the “TAPE END OUT”
setting is flashing.
3Press the l (or j) button, to select the desired
output mode.
–3M . . . . . . . The output becomes 0 V (Low)
when the tape counter reaches
“1H57M00S” and/or when the tape
reaches the end.
END. . . . . . . The output becomes 0 V (Low)
when the tape reaches the end.
4Press the SEARCH/AUDIO ON button to save the
setting.

SW OUT Terminal

When recording, a pulse signal is output at the SW OUT
terminal.
This terminal is usually connected to the switch input (SW
IN) of devices like a camera switcher unit, or a quad
compressor.
SW OUT Terminal Output Setting
1Press the MENU button until the (SET UP 4) menu is
displayed.
ø
The FIELD (or FRAME) setting is flashing.
@@@@@@@<SET@UP@4>
*SW@OUT
@@FIELD@@@@@@@@@01
@@TIMING@@@@@@@@FIELD
@@2H@@@@@@@@@@@@Y
*THREAD@CHECK@@@Y
*VIDEO@LOSS@@@@@N
*REC@SPEED@@@@@@N
NOTE:
XIf “TIMING” is set to FRAME (see step 4),
“FRAME” will be indicated instead of “FIELD”.
2Press the l (or j) button to set the desired pulse
signal interval.
Available settings are:
FIELD. . . . . . 01, 02, 03, 04, 05, 10, 30 or 60 field
FRAME . . . . 01, 02, 03, 04, 05, 10, 30 or 60 frame
3Press the * button, until the “TIMING” setting is
flashing.
4Press the l (or j) button to set “FIELD” or “FRAME”.
FIELD. . . . . . 1 pulse is output after each set
number of fields.
FRAME . . . . 1 pulse is output after each set
number of frames.
5Press the * button, until the “2H” setting is flashing.
6Press the l (or j) button to set the desired “2H”
mode.
Y. . . . . . . . . . When recording in 2-hour mode, a
pulse signal is output.
N . . . . . . . . . When recording in 2-hour mode, a
pulse signal is not output.
7Press the SEARCH/AUDIO ON button to save the
settings.
Tape end or 1
H
57
M
00
S
5V (H)
0V (L)
(Output impedance: 5.7 kΩ)
Output reset
5V (H)
0V (L)
(Output impedance: 5.7 kΩ)
FIELD
FRAME: 16.7 msec.
: 5 msec.
RC4Q/NA2 (TLS-9072 GB) Thu. Sept., 07/2000
English 33