MOUNTING THE LENS

1

2

2

1

2

1

Rewiring the lens cable in the lens iris plug

1Prepare the lens cable.

Cut the cable at the plug, then remove approx. 8 mm of the cable sheath and strip about 2 mm from each wire.

2Install the lens iris plug.

Solder the cable to the pins following the correct pin layout (refer to the table and illustrations), then close the plug cover.

Pin layout

DC type lenses

VIDEO type lenses

1 Brake coil (–)

+12 V DC (50 mA max.)

2 Brake coil (+)

Not used

43

2, 3

43

3 Drive coil (+)

Video output (1.0 Vp-p, high impedance)

4 Drive coil (–)

Ground (for video signal and DC power)

Flange-back adjustment

If the pick-up surface is not correctly positioned with relation to the lens focal point, the picture will be out of focus (in particular when using auto-iris power zoom lenses, sold separately). If that is the case, adjust the flange-back position as described below.

1Using a + screwdriver, loosen the FLANGE BACK LOCK screw (M2:+).

2Set the zoom lens to the maximum telephoto position, set the focus using the focus ring on the lens.

3 ADJ.

1 LOCK

4

3Set the zoom lens to the maximum wide angle position, set the focus using the FLANGE BACK ADJ. screw.

4Repeat steps 2 and 3, until the image stays in focus when changing from a telephoto shot to a wide angle shot. When the setting is complete, tighten the FLANGE BACK LOCK screw.

8 English