SETTINGS

White balance adjustment

Normally the switch 8 (WB) is set to the down (ATW: auto white balance) position and the white balance is adjusted automatically. If a manual white balance adjustment is necessary, follow the steps below.

Set the switch 8 (WB) to the up (M: manual) position, then adjust the colour.

•Turn RED (VR302) to set the red ratio and/or BLUE (VR303) to set the blue ratio.

 

R

B

8

VR302

VR303

 

 

Synchronization settings

The default setting is internal synchronization (INT). You can change the power supply synchronization by moving switch 9 to the up (LL) position. Refer to “Line phase adjustment” for details.

External sync adjustment (VBS) (VCC-6592P only)

1Connect the VBS signal output for the other camera to the VBS IN connector at the rear of this camera.

2If the signals are not synchronized, change the sub-carrier (SC-P1) switches as follows.

 

 

 

 

Setting

 

 

 

 

 

 

9-pin

10-pin

Default

 

 

 

 

 

 

 

OFF (down)

OFF

Set to 90˚ counterclockwise

 

 

 

 

OFF

ON (up)

 

 

 

 

 

 

 

 

 

 

 

 

Set to 180˚ counterclockwise

 

 

 

 

ON

OFF

Set to 270˚ counterclockwise

 

 

 

 

ON

ON

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

VR304

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

9

 

10

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

H-P

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Note:

•The sub-carrier switches let you make broad adjustments to the sub-carrier phase. If finer adjustments are required, contact the place of purchase.

•The type and length of the cable which is connected to the VBS connector may cause the horizontal synchronization being out of phase. If this happens, adjust VR304 (H-P: horizontal sync).

16 English