Manuals / Brands / Photography / Digital Camera / Sanyo / Photography / Digital Camera

Sanyo VPC SX 560, VPC-SX560E, VPC-SX560EX USB cable, AC adaptor, Serial cable, To serial port or USB port, 3-5.Connecting the camera to the computer

1 33

Download 33 pages, 595.07 Kb

3-5. Connecting the camera to the computer

1.Turn off both camera and computer.

2.Line up the arrow on the serial cable connector with the notch on the camera's serial port. Insert the connector.

In case of USB cable, line up the arrow on the USB cable connector with the notch on the camera's USB port. Insert the connector.

3.Line up the serial connector on the serial cable with the serial port on your computer, and insert the connector.

In case of USB cable, line up the USB connector on the USB cable with the USB port on your computer, and insert the connector.

4.Turn on the camera and your computer system.

To serial port or USB port

Serial cable

USB cable

AC adaptor

– 17 –

Contents

(Product Code : 126 279 01) (Europe) (PAL Genenral) (Product Code : 126 279 03) PRODUCT SAFETY NOTICE REFERENCE No. SM5310249 1-1.CA1 CIRCUIT DESCRIPTION Around CCD block Input SHT Buffer XSHT XSG3B 5. Transfer of Electric Charge by the Horizontal CCD The transfer system for the horizontal CCD emplays a 2-phasedrive method (1) (2) (3) 1-2.CA2 CIRCUIT DESCRIPTION 3. LCD Block SVRAM – 6 – 1-3.CA3 CIRCUIT DESCRIPTION 1-4.PW1 POWER CIRCUIT DESCRIPTION 1-5.PW1 STROBE CIRCUIT DESCRIPTION 1-6.SY1 CIRCUIT DESCRIPTION 2. Internal Communication Bus Fig. 4-1Internal Bus Communication System 3. Key Operaiton Table 4-2.Key Operation 4. Power Supply Control Table 4-3.Camera Mode (Battery Operation) 6. Speaker 2-3.REMOVAL OF HOLDER BATTERY AND PW1 BOARD 4. Holder battery 3. Remove the solders 2. Two screws 5. Three screws 4. Two screws 2. Two screws 5. Two connectors 1. Three screws 3. Lens VF 3. ELECTRICAL ADJUSTMENT 3-1.Table for Servicing Tools Ref. No Name Part code 3-5.Connecting the camera to the computer To serial port or USB port Serial cable USB cable AC adaptor 3-6.Adjust Specifications [PW1 board (Side B)] Note: Preparation: 1. IC501 Oscillation Frequency Adjustment 8. Lens Adjustment Adjustment condition: 9.CCD Defect Detect Adjustment 10. LCD Panel Adjustment [CA3 board (Side A)] 10-2.LCD RGB Offset Adjustment Adjust LCD “RGB offset” so that the amplitude of the CL173 waveform is 7.3 ± 0.3 Vp-p CL173 waveform 10-3.LCD Gain Adjustment 4. USB STORAGE INFORMATION REGISTRATION 5. TROUBLESHOOTING GUIDE POWER LOSS INOPERTIVE OFF NORMAL YES N.S.P.: Not available as service parts LOCATIONPARTS NO. DESCRIPTION ELECTRICAL PARTS Materials of Capacitors and Resistors are abbreviated as follows ; Resistors Capacitors MT-FILM COMPL PWB,CA-2 PARTS NO (CRYSTAL DEVICES) (INDUCTORS) (MISCELLANEOUS) COMPL PWB,CA-3 (VARIABLE RESISTOR) COMPL PWB,PW-1 (VARIABLE RESISTORS) (TRANSFORMERS) (JACK) COMPL PWB,SY-1 (INDUCTOR) (SWITCHES) SANYO Electric Co.,Ltd. Osaka, Japan