SECTION III
OPERATING INSTRUCTIONS
3-1 General Safety
Only qualified people familiar with this operator’s manual and the mower’s operator’s manual should operate this machine.
3-2 Operation & Tips On Mowing
A. Perform BEFORE EACH USE maintenance list in paragraph
B. Start the engine/blower/blade assembly. B. Start mower.
C. With the mower at high idle speed, engage the mower deck.
D. Proceed to operate the control levers of the mower.
Note: If the collection system does not appear to be collecting the grass clippings; disengage the deck, and blower, engage the parking brake and turn the mower off. Check the upper hose, lower hose, top screen and boot for clogs.
To obtain the maximum effectiveness from your collection system the tips listed below should be followed:
*Watch your speed- Normal conditions will allow a speed of up to approximately 5 mph, but thick, heavy damp conditions will require reduced ground speed.
*Mow with sharp blades- A sharp blade cuts cleaner.
*Wet grass and leaves will decrease effectiveness and will increase horsepower requirements.
*Mow at higher cutting heights- Remove and mulch no
more than 2” of grass length with each mowing. (Experts recommend not cutting off more than 1/3 of the grass blade length at any given time.)
*Mow twice, at different height settings, (high, then low), if grass is extra tall.
*Remember that horsepower requirements will vary with the mowing conditions such as type and height of turf grass, moisture content, amount of leaves, whether the terrain is flat or sloped, etc.
3-3 Unloading The Collection System
Note: Press the tab, located behind the operator’s left side, downward to feel if the collection system is full. If the container is full there will be resistance when depressing the tab.
A. Stop the forward movement of the mower. B. Disengage the mower deck.
C. Using the throttle cable slow the engine down to idle. D. Push the dump handle, on the left of the operator,
away from the unit. While holding the handle pushed away, move the handle upward. The container door will swing upward and the container will rotate downward. The container will release its contents.
E. Once the contents of the container have fallen out, the container is ready to move back into its normal operating position. With the handle in the ‘away’ position, pull the handle downward until it stops. Move the handle towards the center of the mower. This motion will allow the latch to lock back into collection position.
Note: If you do not hold the handle away from the mower as you pull the handle downward, the latch will not lock and the container can unexpectedly release the contents collected.
SECTION IV
MAINTENANCE
4-1 Maintenance Checklist
Before each use:
1.Check blades and spindles to be sure that no foreign objects, such as wire or steel strapping bands, are wrapped around them.
2.Inspect blades for wear. Replace if necessary. If it is necessary to sharpen the blades, remove the blades from the spindles before sharpening. DO NOT sharpen blades while still attached to the mower.
3.Make sure all shields are in place and in good condition. Repair or replace any missing or damaged shields.
4.Listen for abnormal sounds, which might indicate loose parts, damaged bearings, or other damage. Correct any deficiency before continuing operation.
5.Check for wear or deterioration of the upper or lower hoses. If there are any portions of the hose that have been torn or worn through, replace with genuine PECO parts.
After Each Use:
1.Clean all debris from machine especially from the container, and off of safety decals. Replace any missing or illegible decals.
2.Clean all debris from the box screen.
3.Inspect unit for worn or damaged components. Repair or replace before the next use. Any replacement component installed during repair shall include the components current safety decal specified by the manufacturers to be affixed to the component.
14
