Scag Power Equipment STT61V-25KBD manual Lubrication

Section 7 R

MAINTENANCE CHART - RECOMMENDED SERVICE INTERVALS (CONT'D)

		HOURS
						Procedure	Comments
Break-In	8	40	100	200	500
(First 10)
				X		Apply grease to fittings	See paragraph 7.2
				X		Check hardware for tightness
				X		Change engine oil filter	See paragraph 7.4
				X		Check hydraulic oil level	See paragraph 7.3
					X	Replace engine fuel filter	See paragraph 7.5
					X	Drain hydraulic system and	Use SAE 20W50 Motor Oil.
						replace hydraulic oil	See paragraph 7.3
					X	Replace hydraulic oil filter	See paragraph 7.3

XReplace cutter deck gearbox See paragraph 7.11 lubricant

X Change coolant See paragraph 7.12

7.2 Lubrication

GREASE FITTING LUBRICATION CHART (SEE FIGURE 7-1)

	LOCATION	LUBRICATION INTERVAL		LUBRICANT	NO. OF
					PLACES
1	Caster Wheel Pivot *	500	Hours/Yearly	Chassis Grease	2
2	Caster Wheel Bearings	100	Hours/Monthly	Chassis Grease	2
3	Brake Actuator	200	Hours/MonthlY	Chassis Grease	2
4	Cutter Deck Bellcrank	40 Hours/Weekly		Chassis Grease	4
5	Cutter Deck Pusharms	100	Hours/Monthly	Chassis Grease	2
6	PTO Spindle	40 Hours/Weekly		+Lithium MP White Grease 2125	1
7	Cutter Deck Spindle	40 Hours/Weekly		+Lithium MP White Grease 2125	3
8	Brake Handle	200	Hours/Monthly	Chassis Grease	1
9	Cutter Deck Drive Shaft	40 Hours/Weekly		Chassis Grease	3

+ Compatible Greases:	Mobilix #2 found at Mobil Service Stations
	Ronex MP found at Exxon Service Stations
	Super Lube MEP #2 & Super Stay-M #2 found at Conoco Stations
	Shell Alvania #2 found at Shell Service Stations
	Lidok EP #2 found at industrial shops

* Remove plug and insert grease zerk. Before filling wth grease, remove dust cap from the top of the pivot.

31