Section 4 | R |
PULL BACK | NEUTRAL PUSH FOR |
FOR REVERSE | FORWARD |
“N” FOR NEUTRAL LOCK “D” FOR DRIVE
Figure 4-2. Forward / Reverse Controls
4.6ENGAGING THE DECK DRIVE (CUTTER BLADES)
1.Set the throttle at about 3/4 speed. Do not attempt to engage the deck drive at high speed as this shortens the electric clutch life — use only moderate engine speed when engaging the deck drive.
2.Engage the deck drive by pulling out on the yellow switch, located on the instrument panel, to the engage position. See Figure
WHILE TRAVELING FORWARD, PULL BACK ON LEFT STEERING CONTROL TO STEER LEFT
WHILE TRAVELING FORWARD,PULL BACK
ON RIGHT STEERING CONTROL TO STEER RIGHT
Figure 4-3. Steering Controls
PULL UP TO ENGAGE
PUSH DOWN TO DISENGAGE
390S0138
Figure 4-4. Cutter Engage Switch
CAUTION
Disengage power to the mower before backing up. Do not mow in reverse unless absolutely necessary and then only after observation of the entire are behind the mower.
CAUTION
Before backing up, observe behind the mower for persons and obstructions. Clear the area before backing up. Possible injury or property damage could occur.
- NOTE -
A squealing noise may be heard when engaging or disengaging the deck drive. It is caused by the electric clutch plates meshing as the mower comes up to speed. This is normal.
13
