Mupgrade Utility

For Network Management Cards

User Manual

1 Introduction

This document describes how to use the Network Management Card Firmware Utility software (Mupgrade) to discover, upgrade and configure Network Management Cards linked to the network.

The following functions are available:

-Auto-discovery of your installed base (Model card, IP address, MAC address, firmware card release embedded…)

-Direct link to the card Web interface.

-Firmware upgrade (single card or multicards)

-Import, modify, save, export Network Management Card configuration (single card or multicards)

-Export / import the list of the installed UPS base.

2 Installation

Mupgrade program is available from the www.apc.com Web site, or on the Solution-Pac 2 CDROM.

Run the Setup.exe file and follow the instructions.

A shortcut is placed in the program menu in the group « Schneider Electric »

Note:

If you have UNIX or Linux platform, you cannot use this software but upgrading is possible through TFTP command. Read the Network Management Card user manual to get more information on this function.

#tftp <Entrer> tftp> mode octet tftp> verbose

tftp> put nmc_gb.bin upgrade@password@username <Entrer> Sent 779120 bytes in 85.3 seconds [73096 bits/s] tftp> quit <Entrer>

Note: TFTP upgrade is only working 66074 products.

3 Best environment to use it

This software utility has the best performance if it is principally used in INTRANET architecture. If used in EXTRANET, some limitations can be discovered because of firewalls existence.

Compatible with Microsoft platforms:

Windows 2000

Windows 2003

Windows XP

Windows Vista

Windows 2008

Window Seven

Mupgrade - User Manual

34003662EN/CA

Page 3/18

Page 3
Image 3
Schneider Electric 66074 user manual For Network Management Cards Introduction, Installation, Best environment to use it