Serial port
22
Line parameters The parameters are presented in the following manner:
This tab is used to configure the parameters linked to transmission:
Speed: transmission speed of between 300 and 115 200 bits/s,
Auto-Adaptation: self-adaptation of speed (time during which the driver tries to
connect at a given speed),
Data: specifies the size of the data exchanged over the line,
Parity: is used to set whether a parity bit is added or not, as well as its type,
Stop Bits: is used to enter the number of stop bits used for communication,
RTS/CTS Delay: enables the CTS signal to be used in the event of multidrop
communication.
The Default button is used to reset all these parameters to their default value.
Link Parameters
Speed
seconds
7 bits
Advanced
Uni-Telway
OK Cancel
Parameters of the Station
9600 bits/s
Auto-Adaptation 1
Valid
Use CTS
RTS/CTS Delay X 100 ms
Default
Data Content Parity Stop Bits
8 bits
1 bit
2 bits
Odd
Even
Without
1