Manuals / Schumacher / Power Tools / Battery Charger

Schumacher SI263 manual Charging Preparation, Power, Personal Safety Precautions

Models: SI263

1 32

Page 10

Personal Safety Precautions

•Do not drop any metal tool or metal object onto the battery. This may result in a spark or short circuit across the battery or another electrical device that may cause an explosion.

•Always operate the Battery Manager in an open, well-ventilated area.

•Never smoke or allow a spark or ﬂame in the vicinity of the battery or engine. Batteries generate explosive gases.

•Before attempting to clean up a battery, neutralize any acid spills thoroughly with baking soda.

Charging Preparation

Power

The Battery Manager requires a three-prong grounded 120V AC outlet that meets all local codes and ordinances.

Grounding Pin	Grounding Outlet
	10

SI263 IM 0205v1.indd 10

3/2/05 4:41:07 PM

Page 10

Image 10

Schumacher SI263 manual Charging Preparation, Power, Personal Safety Precautions

Contents

Read and save these instructions Intelligent Battery ManagerSI263 Instructions SI263 IM 0205v1.inddRichard Thalheimer Founder, Chairman and Chief Executive Ofﬁcer Call 1-800-344-4444 for 24-7 ordering and customer serviceDear Sharper Image Customer or go to , our complete online storeWarnings Table of ContentsPersonal Safety Precautions SI263 IM 0205v1.inddTroubleshooting Table of ContentsMaintenance and Care Statement of FCC ComplianceImportant Safety Precautions WARNING - RISK OF EXPLOSIVE GASESWarnings Do not expose the Battery Manager to rain or snow WarningsNever operate the Battery Manager if it has received a hard blow, been dropped or otherwise damaged. Take it to a quali- ﬁed service professional for inspection and repair WarningsPersonal Safety Precautions Charging Preparation PowerPersonal Safety Precautions Features Extension Cord Use Extension Cord Minimum RecommendedBattery Preparation Operation Charging Battery in the VehicleBattery Preparation Charging Battery in the Vehicle 3. To determine the polarity of the battery posts, check the iden- tiﬁcation marks on the battery POSITIVE POS, P or + and NEGATIVE NEG, N or -. The positive post is usually marked red and is larger than the negative postNegative-Grounded System Standard 6. Clean and store the Battery Manager in a dry location Positive-Grounded SystemNegative-Grounded System Standard Charging a Removed Battery Charging a Removed Battery 8. Clean and store the Battery Manager in a dry locationOperating Features Charge RateBattery Type Button Battery Type Button General NotesMaintain Mode When the CHARGED green LED is illumi- nated, the Battery Manager switches automatically to Maintain Mode. The Battery Manager monitors battery voltage. When the voltage drops to a predetermined level, the Battery Manager will re-initiate a charge cycle at the 2A rate Charging Tips Maintenence and Care SOLUTION TroubleshootingPROBLEM POSSIBLE CAUSESOLUTION TroubleshootingPROBLEM POSSIBLE CAUSEPOSSIBLE CAUSE SOLUTION TroubleshootingPROBLEM This happens if thePROBLEM TroubleshootingNo problem. This is SOLUTION TroubleshootingPROBLEM POSSIBLE CAUSEStatement of FCC Compliance Statement of FCC Compliance FCC Label Compliance StatementReorient or relocate the receiving antenna What Is Not Covered WARRANTYWhat Is Covered How to Obtain Service