Manuals / Schumacher / Power Tools / Battery Charger

Schumacher SI263 manual Troubleshooting, Problem, Possible Cause Solution, This happens if the

Models: SI263

1 32

Download 32 pages 19.34 Kb

Page 27

Image 27

Troubleshooting

PROBLEM

POSSIBLE CAUSE SOLUTION

The CHECK	This happens if the
(red) LED always	battery does not
ﬂashes before the	reach full charge
battery is com-	within 24 hours.
pletely charged.	May be due to a
	very large battery
	or a bank of batter-
	ies requiring more
	power than the
	Battery Manager
	can deliver in 24
	hours. The battery
	may also be
	defective.

Reset the Battery Manager by unplug- ging it. Select the desired charge rate and battery type again, if necessary.

SI263 IM 0205v1.indd 27

3/2/05 4:41:09 PM

Page 27

Image 27

Schumacher SI263 manual Troubleshooting, Problem, Possible Cause Solution, This happens if the, or a bank of batter

Contents

SI263 IM 0205v1.indd Intelligent Battery ManagerSI263 Instructions Read and save these instructionsor go to , our complete online store Call 1-800-344-4444 for 24-7 ordering and customer serviceDear Sharper Image Customer Richard Thalheimer Founder, Chairman and Chief Executive OfﬁcerSI263 IM 0205v1.indd Table of ContentsPersonal Safety Precautions WarningsStatement of FCC Compliance Table of ContentsMaintenance and Care TroubleshootingWARNING - RISK OF EXPLOSIVE GASES Important Safety PrecautionsWarnings Warnings Do not expose the Battery Manager to rain or snowWarnings Never operate the Battery Manager if it has received a hard blow, been dropped or otherwise damaged. Take it to a quali- ﬁed service professional for inspection and repairPersonal Safety Precautions Power Charging PreparationPersonal Safety Precautions Features Extension Cord Minimum Recommended Extension Cord UseBattery Preparation Charging Battery in the Vehicle OperationBattery Preparation 3. To determine the polarity of the battery posts, check the iden- tiﬁcation marks on the battery POSITIVE POS, P or + and NEGATIVE NEG, N or -. The positive post is usually marked red and is larger than the negative post Charging Battery in the VehicleNegative-Grounded System Standard Positive-Grounded System 6. Clean and store the Battery Manager in a dry locationNegative-Grounded System Standard Charging a Removed Battery 8. Clean and store the Battery Manager in a dry location Charging a Removed BatteryCharge Rate Operating FeaturesBattery Type Button General Notes Battery Type ButtonMaintain Mode When the CHARGED green LED is illumi- nated, the Battery Manager switches automatically to Maintain Mode. The Battery Manager monitors battery voltage. When the voltage drops to a predetermined level, the Battery Manager will re-initiate a charge cycle at the 2A rate Charging Tips Maintenence and Care POSSIBLE CAUSE TroubleshootingPROBLEM SOLUTIONPOSSIBLE CAUSE TroubleshootingPROBLEM SOLUTIONThis happens if the TroubleshootingPROBLEM POSSIBLE CAUSE SOLUTIONTroubleshooting PROBLEMNo problem. This is POSSIBLE CAUSE TroubleshootingPROBLEM SOLUTIONStatement of FCC Compliance FCC Label Compliance Statement Statement of FCC ComplianceReorient or relocate the receiving antenna How to Obtain Service WARRANTYWhat Is Covered What Is Not Covered

POSSIBLE CAUSE SOLUTION

This happens if the

or a bank of batter-