Manuals / Schumacher / Power Tools / Battery Charger

Schumacher SI263 manual FCC Label Compliance Statement, Statement of FCC Compliance

Models: SI263

1 32

Download 32 pages 19.34 Kb

Page 31

Image 31

Statement of FCC Compliance

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experienced radio/TV technician for assistance.

FCC Label Compliance Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

SI263 IM 0205v1.indd 31

3/2/05 4:41:09 PM

Page 31

Image 31

Schumacher SI263 FCC Label Compliance Statement, Statement of FCC Compliance, Reorient or relocate the receiving antenna

Contents

SI263 IM 0205v1.indd Intelligent Battery ManagerSI263 Instructions Read and save these instructionsor go to , our complete online store Call 1-800-344-4444 for 24-7 ordering and customer serviceDear Sharper Image Customer Richard Thalheimer Founder, Chairman and Chief Executive OfﬁcerSI263 IM 0205v1.indd Table of ContentsPersonal Safety Precautions WarningsStatement of FCC Compliance Table of ContentsMaintenance and Care TroubleshootingWARNING - RISK OF EXPLOSIVE GASES Important Safety PrecautionsWarnings Warnings Do not expose the Battery Manager to rain or snowWarnings Never operate the Battery Manager if it has received a hard blow, been dropped or otherwise damaged. Take it to a quali- ﬁed service professional for inspection and repairPersonal Safety Precautions Charging Preparation PowerPersonal Safety Precautions Features Extension Cord Minimum Recommended Extension Cord UseBattery Preparation Operation Charging Battery in the VehicleBattery Preparation 3. To determine the polarity of the battery posts, check the iden- tiﬁcation marks on the battery POSITIVE POS, P or + and NEGATIVE NEG, N or -. The positive post is usually marked red and is larger than the negative post Charging Battery in the VehicleNegative-Grounded System Standard 6. Clean and store the Battery Manager in a dry location Positive-Grounded SystemNegative-Grounded System Standard Charging a Removed Battery 8. Clean and store the Battery Manager in a dry location Charging a Removed BatteryCharge Rate Operating FeaturesBattery Type Button Battery Type Button General NotesMaintain Mode When the CHARGED green LED is illumi- nated, the Battery Manager switches automatically to Maintain Mode. The Battery Manager monitors battery voltage. When the voltage drops to a predetermined level, the Battery Manager will re-initiate a charge cycle at the 2A rate Charging Tips Maintenence and Care POSSIBLE CAUSE TroubleshootingPROBLEM SOLUTIONPOSSIBLE CAUSE TroubleshootingPROBLEM SOLUTIONThis happens if the TroubleshootingPROBLEM POSSIBLE CAUSE SOLUTIONPROBLEM TroubleshootingNo problem. This is POSSIBLE CAUSE TroubleshootingPROBLEM SOLUTIONStatement of FCC Compliance Statement of FCC Compliance FCC Label Compliance StatementReorient or relocate the receiving antenna How to Obtain Service WARRANTYWhat Is Covered What Is Not Covered