Step 7: Install Feet
Parts
•Main Unit (from Step 6)
•#2 - Left Foot (Qty. 1)
•#3 - Right Foot (Qty. 1)
•#14 - Foot Mount Plate (Qty. 1)
Hardware
•#24 - M8 Flat Washer (Qty. 8)
•#25 - M8 Lock Washer (Qty. 8)
•#29 - M8x15 Hex Screw (Qty. 4)
•#32 - Round Cover (Qty. 2)
•#33 - Cotter Pin (Qty. 2)
•#34 - M8x20 Hex Screw - Nylock (Qty. 2)
•#35 - M8x25 Hex Screw - Nylock (Qty. 2)
Tools
•Phillips Head Screwdriver
•Combination Wrench (Qty. 2)
Do steps 7-1 thru 7-3 on one side and then again on the other side.
7-1Move the shaft under the pedal into the pivot on the Leg Assembly. Align a Foot Mount Plate with the pivot and the Foot Assembly. Attach with three M8 Locking Washers, three M8 Flat Washers, two M8x15 Hex Screws (outside holes), and one M8x20 Hex Screw (center hole).
7-2Set the Foot Assembly in the U-bracket at the bottom of the Lower Handlebar. Put a Cotter Pin from the inside through the U-bracket and Foot assembly. Attach with M8x25 Hex Screw, M8 Lock Washer, and M8 Flat Washer.
NOTE: Make sure the key on the Cotter Pin engages the slot in the U-bracket.
7-3Tighten the screws holding the arms and then put a Round Cover over the head of each screw.
7-4Fully tighten all hardware in Steps 6 and 7.
