Introduction

Back Panel Description

The following illustration shows the description and function of the back panel components on the DPX2213.

 

 

 

TELEPHONE REBOOT

CABLE

USB

ETHERNET

1/2

2

EMTA

POWER

1

2

3

4

5

6

T11715

Important! Do not connect your PC to both the Ethernet and USB ports at the same time. Your modem will not function properly if both the Ethernet and USB ports are connected to your PC at the same time.

1POWER – Connects the cable modem to the AC power supply that is provided with your cable modem.

CAUTION:

Avoid damage to your equipment. Only use the AC power cord that is provided with your cable modem.

2CABLE – F-Connector connects to an active cable signal from your cable service provider.

3USB – 12 Mbps USB port connects to the USB port on your PC.

4ETHERNET – RJ-45 Ethernet port connects to the Ethernet port on your PC or your home network.

5TELEPHONE 1 / 2 – RJ-11 telephone ports connect to home telephone wiring to conventional telephones or fax machines.

6REBOOT EMTA – Pressing this switch reboots the EMTA. Pressing this switch for more than ten seconds resets the device to factory default values and reboots the EMTA.

CAUTION:

The Reboot EMTA button is for maintenance purposes only. Do not use unless instructed to do so by your cable or telephone service provider. Doing so may cause you to lose any cable modem settings you have selected.

734348 Rev C

7