26 Medalist SL Family Installation Guide, November 1995
∙Check the
∙Verify the drive type setting in System Setup. The drive- type values used to configure System Setup must not exceed the physical specifications of your drive (see the translation geometry table on page 20). Also, if you have an older BIOS, the translation geometry values must not exceed the limita- tions set by the BIOS.
∙Check for viruses. Before you use someone else’s diskette in your system for the first time, scan the diskette for viruses.
Advanced troubleshooting
If you have performed the preceding basic checks but the prob- lem has not been solved, follow these guidelines for troubleshoot- ing specific cases:
The system does not recognize the drive.
∙Check all cables.
∙Make sure the power supply is adequate for system needs.
∙Reboot the computer and make sure the drive motor runs. If your drive is very quiet, it may be difficult to hear its discs reach operating speed. Recheck all drive cables if the drive is not running.
∙Verify the System Setup drive type values. Each drive present must be represented in System Setup.
∙Try a warm boot (a reboot without turning off computer power). To do this, press CTRL, ALT, and DELETE at the same time.
If the drive is recognized after the warm boot, the computer
