Sears 113.244501 manual Maintenance, Sears recommends the following accessories, Co,a ,lo,t

maintenance

WARNING: For your own safety, turn switch "OFF", remove switch key and remove plug from power outlet before maintaining

or lubricating your band saw.

TIRES

Pitch and sawdust that accumulates on the tires should be removed with a stiff brush or scraped off with a piece of wood Do not use a sharp knife or any kind of solvent

GENERAL

Keep your Band Saw clean

Remove sawdust from the inside frequently

Do not allow pitch to accumulate on the table, blade

guides, or thrust bearings Clean them with Craftsman Gum and Pitch Remover

Apply a thin coat of automobile-type wax to the table top so the wood slides easily while cutting Also apply wax to the inside surfaces of the trunnion

MOTOR/ELECTRICAL

Frequently vacuum or blow out any sawdust from the motor

or damaged in any way, have it

f WARNING: If the power cord is worn, cut, replaced immediately.

WARNING: To avoid fire or electrocution, reassemble electric parts with only approved service parts. Reassemble exactly as originally assembled.

LUBRICATION

A!t of the BALL BEARINGS are permanently lubricat- ed They require no further lubrication

Wiring Diagram

{ co,a ,lo,t

WhiteWhile

Black

.J__Green

Ground Screw

_, i i IM I1,,I,' III I_ It1 III I I Ir I IIII '1I

sears recommends the following accessories

Sears may recommend other accessories not listed in manual

See your nearest Sears Store or Catalog Department for other accessories

Do not use any accessory unless you have received and read complete instructions for its use

Item	Cat. No.
Miter Gauge	_)-24214
Blades (56-7/8" length)	See Catalog
Leg Set	9-22244
Power Toot Handbook	9-29117

19