MAINTENANCE
SWITCH REPLACEMENT
See Figures 15 & 16.
1.UNPLUG YOUR ROUTER.
2.Remove screws (A) and handle cover (B). See Fig. 15.
3.NOTE THE LOCATION OF MOLDED BEND RELIEF
(C)ON POWER HANDLE CORD AND ALL WIRING
IN HANDLE. ALSO NOTE HOW EACH LEAD IS
CONNECTED TO SWITCH. The side | of the variable | B |
speed control switch Is marked with Identification |
| |
numbers. Connections and wiring position must be |
| |
Identical when Installing new switch. | See Figure 16. | 1/32 IN. DIAMETER NAIL OR PIN |
4.Remove leads from switch (D) by inserting a 1/32 in. diameter nail or pin into switch lead receptacle and pulling on lead as shown in figure 16. Remove nail or pin with a twisting, pulling motion.
5.Make lead connections to the new switch. Push each
| lead as far as possible into proper receptacle in switch. | VIOLET | VARIABLE |
|
| Pull on leads to check lead connections with I_ad re- | SPEED |
| |
| ceptacles. |
| SWITCH | LIGHT |
|
|
| ||
6. | Locate switch in handle and place leads so they won't |
| RED |
|
| be pinched or contact screws when handle cover is |
|
| |
|
|
|
| |
| replaced. |
|
|
|
7. | Make sure molded bend relief (C) is correctly positioned |
|
|
|
| in switch handle, then replace handle cover and screws. |
|
|
|
8. | Tighten all screws securely. |
|
|
|
DEPTH ADJUSTING RING
POWER
ADJUSTMENTS OR REPLACEMENTHANDLE
CORD
Tension on the depth adjusting ring has been factory set for propedy tightening depth of cut settings. However, ex- tended use may require that adjustments or replacement be made to depth adjusting ring. See Figures 17- 19.
1.UNPLUG YOUR ROUTER.
To make adjustments to depth adjusting ring:
2.Tighten or loosen top screw in depth adjusting ring. See Figure 17. Make adjustments with top screw only.
To replace depth adjusting ring:
. Removedepth stoprings. To remove: Depress lipon depthstop ringand slideend of depthstop ringover lip. See Figure 17.
4.Removescrew from rear of depthadjustingring, See
Figure18.
Page 12
