Preparethe Top Thread

o Thread the Needle

SECTION 2. PREPARE THE MACHINE FOR SEWING
The numbered steps above follow the numbers
on the illustrations.
Dotted lines show places where the thread
loops and then is pulled tight.
Raise take-up lever to its highest position by turning hand wheel toward you,
Raise presser toot lever,
Place the spool on the spool pin as shown, with thread coming lrom the back ofthe spool.
tl.
2.
3.
4.
5.
6.
NOTE:
Draw thread into thread guide using both hands.
While holding thread near spool, draw thread down into the tension area and then around the
check spring holder.
Firmly draw thread up andthrough take-up lever from right to left.
Draw thread down and slip it through the thread guide.
Thread then isslipped into needle bar thread guide.
Thread needle from front to back.
Cut the end ofthe thread with sharp scissors for easier needle threading.
19