iMPORTANT SAFETYINSTRUCTIONS
Your sewing machine is designed and constructed only for HOUSEHOLD use.
Read all instruction before using this sewing machine.
DANGER- o reduce the risk ot electric shock:
2.
3.
4.
An appliance should never be left unattended when plugged in. Always
unplug this appliance from the electric outlet immediately after using and
betore cleaning.
Always unplug before refamping. Replace bulb with same type rated 15
Watts.
Do not reach for the appliance that has tallen into water. Unplug
immediately.
Do not place or store appliance where it can tall or be pulled into a tub or
sink. Do not place in or drop into water or other liquid.
WA RNING- Toreduce the risk ot burns, fire, electric shock,
or injury to persons.
2,
.
Do not allow to be used as a toy. Close attention is necessary when this
appliance is used by or near children.
Use this appliance only for its intended use as described in this manual.
Use only attachments recommended by the manufacturer as contained in
this manual.
Never operate this appliance if it has a damaged cord or plug, if it is not
working properly, if it has been dropped or damaged, or dropped into
water. Return the appliance to the nearest authorized dealer or service
center torexamination, repair, electrical or mechanical adjustment.
4o
,
6.
7.
8.
Never operate the appliance with any air opening blocked. Keep
ventilation openings of the sewing machine and toot controller free from
accumulation of lint, dust, and loose cloth.
Never drop or insert any object into any opening.
Do not use outdoors.
Do not operate where aerosol (spray) products are being used or where
oxygen is being administered.
To disconnect, turn all controls to the off I"0") position, then remove plug
trom outlet.
9. Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
10. Keep fingers away trom all moving pads. Special care is required around
the sewing machine needle.
11.
t2.
13.
14_
15.
Always use the proper needle plate. The wrong plate can cause the
needle to break.
Do not use bent needles.
Do not pull or push labric while stitching.
It may deflect the needle causing it to break.
Switch the sewing machine off ("0") when making any adjustment in the
needle area, such as threading needle, changing needle, threading
bobbin, or changing presser foot, and the like.
Always unplug the sewing machine from the electrical outlet when
removing covers, lubricating, or when making any other adjustments
mentioned in the instruction manual.
SAVE THESE INSTRUCTIONS