
| SERVICE | AND | ADJUSTMENT |
HOW TO SET THE HEIGHT | OF CUT |
|
|
The height of cut is sat at the factory from | 1'/_to 4inches | To lower |
|
or raise the height of cut make an adjustment to the | lifter rod | Hair Pin | |
as follows |
|
|
|
1Move the lift lever to the LOW cut position
2 Disconnect the lifter rod from the lifter arm
3 Turn the lifter rod clockwise to lower or counterclockwise to
raise the height of cut
4 Attach the lifter rod to the lifter arm
5Move the lift lever to the HIGH position Make sure the pulleys or belt do not touch the bottom of the frame
HOW TO START WITH A WEAK BATTERY
Ifthebatteryistooweaktostarttheenginethebatteryneedstobe
charged If "Jumper Cables" are used to start the engine in an
emergency folfowthe procedure below
NOTE: The unit is equipped with a 12 volt negative to ground
system Also, the other vehicle must have a 12 volt negative to ground system
WARNING: Do not smoke The fumes from the
battery acid can cause an explosion Keep the
battery away from any flames or sparks To prevent sparks, fasten the red jumper cable to
the positive (+) terminal before connecting the black jumper cable
1 Put a wet cloth over the vent caps of each battery
2Connect each end of the RED'Jumper Cable" to the positive (+) terminais of each battery Make sure you do not touch the chassis with the cables
3Connect one end of the BLACK ",Jumper Cable" to the negative
4Connect the other end of the BLACK "Jumper Cable" to the
engine block
5Start the engine that has the weak battery last Allow the engine to run
6To disconnect the "Jumper Cables" reverse the above steps
HOW TO CLEAN THE MOWER HOUSING | HOW TO REPLACE THE FUSE |
ing, stop the engine and disconnect the wire to
_WARNING: Before you clean the mower hous- the spark plug
Grass and other debris on top of the mower housing can keep the belt from working correctly Clean the mower housing as follows
1Move the lever for the blade engagement control to the
ENGAGE position
2Clean the top of the mower housing
3Move the lever for the blade engagement control to the DISENGAGE position
4Again clean the top of the mower housing
5After you cut the grass, clean the bottom of the mower
housing | 29 |
|
If the fuse is blown the enginewitlnot start Thelocationofthe fuse
is next to the battery Remove the fuse and replace with a
15 amp Automotive fuse
FRONT WHEEL ALIGNMENT
The alignment of the front wheels cannot be adjusted If the
steering is damaged and the alignment has changed see your nearest Sears Service Center