CUSTOMER RESPONSIBILITIES
SNOW THROWER
LUBRICATION - EVERY TEN HOURS
Auger Shaft - Using a hand grease gun, lubricate the auger shaft zerk fittings (See A, FIG, 2) every ten (10) operating hours. Each time a shear bolt is replaced
(See To Replace Auger Shear Bolt paragraph in the Service & Adjustments eectlon of this manual), the auger shaft MUST be greased.
For storage or when replacing shear bolts, remove shear bolts and lubricate auger shaft zerks. Rotate augers several times on the ._haft and reinstall the shear bolts.
LUBRICATION - EVERY 25 HOURS
•Position speed selector lever in first gear.
•Place a coin or (a shim of equal thickness) between the rubber friction whee= and disc drive plate to pre- vent friction wheel contacting the friction disc.
Disc Drive Plate - Using a hand grease gun, lubricate with a Hi Temp EP M oly grease, zerk located beneath the disc drive plate (See FIG. 3 inset) every 25 hours and at the end of the season and/or before storage. To grease zerk, turn disc drive plate clockwise by hand until zerk is clearly visible at front center. DO NOT overfill or allow grease to come in contact with the disc drive plate or friction wheel or damage will result. Fill zerk only until grease becomes visible below bearing assembly located under grease zerk. See Lubrication Chart in this seCtion.
•IMPORTANT: Remove coin and ensure that a gap exists between friction wheel and disc drive plate.
•NOTE: Clean all excess grease found on friction disc hub.
AXLE_
FIG. 1
FIG. 2
HEX SHAFT AND GEARS
FRICTION
WHEEL
DISC
DRIVE
PLATE
/
•CAUTION: Do not allow grease to contact friction wheel and disc drive plate.
FRICTION
WHEELGRF-ASI
LUBRICATION - BEFORE STORAGE
•Remove both wheels, grease (any automotive type grease) both axles (See FIG. 1) and replace wheels. Do this at least once a year and/or prior to storage.
ASSEMBLY
be visible
FIG. 3
