ASSEMBLY
TOOLS REQUIRED FOR ASSEMBLY
1 - Knife (to cut carton and plastic ties/
2 - 1/2 inch wrenches (or adjustable wrenches)
2 - 9/16 inch wrenches (or adjustable wrenches}
2- 3/4 inch wrenches (or adjustable wrenchesl
1 - Pliers (to spread cotter pin)
1- Screwdriver
1 - Measuring tape or ruLer
Figure 1 shows the snow thrower in the shipping position Figure 2 shows the snow thrower completely assembled.
Reference to the right and left hand side of the snow thrower is from the operator's position at the handle.
TO REMOVE SNOW THROWER
FROM CARTON (See FIG. 1)
•Remove packaging inserts located at lour corners of carton.
•Locate and remove container o! 5W30 oil found in rear, right, carton insert.
•Cut all four corners of the carton from top to bottom and lay the panels llat.
•Cut and discard plastic ties securing augers and wheel axles to the pallet.
•Cutand discard plasticties and bagsthat secure crank assembly and place assembly aside
•Cut and discard plastic ties securing clutch cables to lower handle.
•Remove plastic wrap from upper handle which was used to protect clutch levers
•With the two 9/16" wrenches, loosen (but do not remove) both bolts securing the upper and lower handles by holding the inner nut on the inside ot the handle while turning the outside boll
•Swing upper handle up into operating position as shown in FIG. 2. Hold the inner nut and tighten [ne outside bolt up against the handle
LEVERLEVER
CABLE
CABLE
MBLY
SHIFTER
LEVER
DEFLECTOR
FIG. 2
CAUTION: IF YOU ARE REMOVING
SNOW FROM ANY GRAVELED OR UN- EVEN SURFACE, RAISE THE FRONT OF
THE SNOW THROWER BY MOVING THE SKIDS DOWN. THIS WILL HELP TO PREVENT STONES AND OTHER DEBRIS FROM BEING PICKED UP AND THROWN BY THE AUGER.
LOWEr HANDLE
FIG. 1
CONTROL
PANEL
CLUTCH
UPPER
HANDLE
ASSEMBLY
7
