CARBURETOR
If you think your carburetor needs adjusting, see your nearest Sears Service dealer. Engine performance may be affected above 4,000 feet in altitude. To improve engine performance, see your nearest Sears Service dealer.
Remove additional debris by back flushing water sup- ply through wand. Back flush between 30 to 60 sec- onds. Turn wand to stream spray and move nozzle from low to high pressure while flushing.
NOZZLE MAINTENANCE
If the nozzle becomes restricted or clogged with foreign materials, such as dirt, excessive pump pressure may develop. A partially clogged nozzle can cause a pulsing sensation during use. This generally is not a pump relat* ed problem, but rather a clogged or partially restricted nozzle.
If the nozzle becomes clogged or partially restricted, immediate{y clean the nozzle with the kit included with your pressure washer by following these instructions:
•Shut off the engine and turn off the water supply.
•Separate the wand from the gun.
•Rotate to stream setting.
oRemove nozzle from the end of the wand using a 2ram or 5/64 allen wrench 0ike the one included in the kit).
•Use the wire included in the kit or a small paper clip to free the foreign materials clogging or restricting the nozzle.
,Reinstall nozzle into wand. DO NOT overtighten, = Reconnect wand extension to spray gun.
,Reconnect the water supply, turn ON the water, and start the engine.
•Test the pressure washer by operating with nozzle in the high and the low pressure positions.
Insert wire into nozzle and turn back and forth to clear obstruction.
]3
