Sears 580.761652 manual To Start Your Pressure Washer, Add Gasoline

@Wipe dipstick clean.

Pour oil from enclosed bottle into the oil fill opening until oil reaches FULL mark on the dipstick. Stop and check the oil level periodically. DO NOT OVERFILL.

Install oil dipstick, hand tighten securely.

ADD GASOLINE

WARNING NEVER fill fuel tank indoors. NEVER fill fuel ta'nkwhen engine is running

or hot. DO NOT light a cigarette or smoke when filling the fuel tank.

_1_ AUTION: Do not overfill the fuel tank. Always leave room for expansion.

Use regular UNLEADED gasoline with the pressure washer engine. Regular leaded gasoline may also be used if UNLEADED is not availabte. Fuel tank capacity is 1 U.S. quart.

IMPORTANT: It is important to prevent gum deposits from forming in essential fuel system parts such as the carburetor, fuel filter, fuel hose or tank during storage. Also, experience indicates that alcohol-blended fuels (called gasohot, ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. See "Storage" on page 14. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

Place the pressure washer in an area close enough to an outside water source that can flow at a rate of 3

gallons per minute. Connect a garden hose to the water spout.

Check that the high pressure hose is tightly connected

to the spray gun and to the pump. See ASSEMBLY section for illustrations.

Remove the female quick-connect from pump. Check inlet screen. If the screen is dirty, clean before attaching to garden hose. If the screen is damaged, Do not connect to the garden hose. Call the pres*

sure washer customer helpline to order a replace- ment.

Attach the female quick-connect to garden hose and then attach the garden hose to the water inlet. Push

until you hear the quick-connect "click,"

MALE _.

CONNECTOR

GARDEN

HOSE_

Turn on the water.

•Clean area around fuel fill cap, remove cap.

oSet Throttle Control Lever to RUN position.

•Add "UNLEADED" regutar gasoline, slowly, to fuel tank.

•Install fuel cap and wipe up any spilled gasoline.

Remove the wand extension and squeeze the trigger to purge pump system of air and impurities then

engage the safety latch on spray gun by pushing lever upward toward the top of the handle. This disables the

trigger so you cannot inadvertently actuate a high

pressure spray, z_

TO START YOUR PRESSURE WASHER

You have assembled your high pressure washer and have prepared the engine for starting, You are now ready to clean your car, boat or the outside of a building or whatever you plan to clean.