pour or spill water intocontrol or
motor area, If co_rols get wet, let
them dry completely and have unit
checked byauthodzed service per-
sonnel before plugging ItIn.
IMPORTANT
Be sure water does not go above FULb
mark or water will overflow from the
hole located in the _vater level indica.
for label.
:_r!_with cleanwater up to FULL indi-
cator label, located inside the housing on
the rear panel(Figure 4).
NOTE: Do not overfill humidifier. Water
will overflow from the_overfill hole if
capacity is exceeded.
Step2
Carefullypourwater into humidifier.(Pour
water at left of the controlsas shown in
Figure4.) OVERFILL
HOLE
Figure4
Operating Humidifier Controls IIIII1[
Humidity Control:
Adjustthe amount of humidity depending
on user's needs. The humidifierwill turn
on and off as required to maintain level of
humidity you select. (See Figure 5.)
MEDIUM setting is recommended but
thereare timeswhen low or high amount
of humidity may be preferred. For con-
stantoperation of humidifier,CONSTANT
ON allows for the maximum amount of
humidity to be evaporated into the air
continuously.
IMPORTANT
Water damage may result ff condensa-
tion starts to form on windows or
walls. Humidify Control setting should
be lowered until condensation no
longer forms.
Air Flow Control:
The higher the airflow speed, the more
water is evaporated and released intothe
air. LOW _peecListhe quietest and is pro-
vided for conditionsthat may not require
as high an evaporationrate. (See Figure
5.)
Fill Light:
When unit has a small amount of water
leftin it, a orange fill lightwill come onand
unitwillshut off.(See Figure 5.)
Figure5