.Press the two H_ndlebar Endcaps (13) onto the
Pedal Frame (7).
Insert the Handlebar (2) intothe Pedal Frame
(7). Be sure that theHandlebar istumed as
shown. Attach the Handlebar to the Pedal
Frame with four #8 x 1/2" Screws (16).
4. Lubricate the indicated axleson the Pedal
Frame (7). Slide a Pedal (12)onto each axle.
Be sure that the Pedals aretamed so the
rounded ends face awayfrom the Pedal Frame.
Using the includedpedal tool, tap a 112" Push
Nut (30) onto each of the axles. Sea the inset
drawing. Make sure that the Push Nuts are
turned as shown, with the teeth pointing
away from the Pedal Frame (7).
Attach two Pedals (12) to the other side of the
Pedal Frame (7) in the same manner.
5. Turn the Seat Knob (35) to loosenit. Pull down
the Seat Knob and hold it,Slide the Seat (3)
onto the Seat Frame (5) and move the Seat to
the desired position. Release the Seat Knob.
Slide the Seat back and forth slightly until the
Seat Knob locks intoplace. Turn the Seat Knob
to tighten it. Push on the Seat to make sure
that the Seat Knob Is engaged in one of the
holes in the underside of the Seat Frame.
3
2,
7 J ,3---L P a,TooY
"I _Teeth
55
35
6_