Sears 8EAIRS 5oPullthedrawerpartway out.Reachin,pushtherearj, oftheglassup atthesame, Condenser

5oPullthedrawerpartway

out.Reachin,pushtherearj ........

oftheglassup;atthesame

time,pushit backuntilit clearsfront-cornerretainers

6oTiltandremovethecover

7.Pullthedrawerforward,

liftthefronttoclearstops,

andpullthedraweroutuntil ithitsthedoorThenliftthe

drawerupuntilit ishigher thanthedrawersupports, tiltit andtakeitouL

8.If tape hotds bottom drawer cover to drawer supports, remove the tape_ Pull drawer partway out

Reach in, push the rear of the glass up and, at the same time, back, until it dears front-corner retainers,

9.Tilt and remove the cover,

10.Tilt and remove the drawer

After cleaning, replace drawers and covers in reverse order Reinstall the gasket at the rear of the top drawerr Fitthe end of the plastic

drawer support into the slot on the gasket, with the rubber gasket flap facing you Make sure the gasket snaps into

Then repIace the light panel by hanging top of panel on

place

upper pins and pushing in at bottom

Drain Opening in Freezer Compartment

When cleaning, remove Il! the freezer bin and flush

a solution of baking soda (one teaspoon) and two cups of hot (not boiling) water through the drain line with the help of a meat baster This will help eliminate odor and reduce

the likelihood of a clogged drain line,

If drain becomes clogged, use a meat baster and baking- soda-and-water solution to force the clog through the drain llne

Behind Refrigerator

Take care moving your refrigerator away from the wall. All types of floor coverings can be damaged, particularly cushioned coverings and those with embossed surfaces Pull the refrigerator straight out and return it to position by pushing it straight in Moving refrigerator in a side direction may damage floor covering or refrigerator

Condenser

The condenser is located behind the base grille For most efficient operation, remove the base grille (see page 3) and sweep away or

vacuum up dust that is readity accessible For best results, use a brush specially designed for this purpose. It is available at your Sears store or service center, This easy cleaning operation should be done at least once a year

Light Bulb Replacement

Unplug refrigerator before changing a light bulb,

Fresh Food Compartment-Upper Light

1. Pull off temperature

control knobs Pin

2, PuTIthe bottom of the

fight shield down and forward, then rotate the top up and off

After replacing with same size bulb, reinsta!l light shield

Fresh Food Compartment-Lower Light (on some models)

This light islocated behind a shield at the rear of the fresh food compartment

1.Grasp the top edge of the shield and lift it up and forward to free itstop edge

2.After replacing with same size bulb, hook the top of the shield back in place

Freezer Compartment

1_Remove shelf just below

light panel (Shelf will be easier to remove if it is

emptied first )

2.Puff plastic light panel toward you, (It will bend to free tabs from grooves)

3.After replacing with same size bulb, reinstall panel and shelf,

Convenience Center

1.Remove top door bin and raise Convenience Center

inner door

2.Press sides of flexible light

panel to release locking tabs and a!low the panel to swing down,

3° After replacing with night-lightbulb of same wattage, place rear tab of light panel into door and rotate panef up until tabs lock into slots above

17