Sears 8EAIRS owner manual Electronic Alert & Diagnostic System continued

Electronic Alert & Diagnostic System (continued)

The Electronic Alert and Diagnostic System

alerts you when something starts to go wrong

tf a system code appears on the display, something needs special attention_ To get your attention, the display code flashes until you erase it The first 6 flashes are accompanied by beeps_

If more than one coded function requires attention at the same time, the one with the highest priority will be displayed firsL

Pressing the SYSTEM CHECK-RESET pad wiI! evaluate all other coded functions If the NORMAL display is lit during the displaying of o code, that function is operating properly

Pressing the SYSTEM CHECK-RESETpad will erase two codes immediately-PF,and CI The DE and

FFcodes can only be erased by touching the

SYSTEM CHECK-RESETpad after the condition that caused the code to flash has been corrected.

This flashing code tells you the power to the refrigerator has

been interrupted for more than 2 seconds Check the condition

of food in both the Freshfood and freezer compartments Touch

SYSTEM CHECK-RESET pad to erase code,.

There is no fault with the refrigerator when PFcode flashes,

This flashing code tells you something's wrong with the defrost

system- keep doors closed to retain cold and call for servicer

Code flashes until problem is corrected

This flashing code tells you to check your frozen food. Has any of it started to thaw?

A package may be holding the freezer compartment door open Don'topen the door more often than absolutely necessary while this code is displayed Touching the SYSTEM CHECK-RESET pod after the freezer

compartment temperature has returned to norma{ wil! erase the code

This flashing code tells you to check the automatic icemaker.

Ice clumps in the storage bin may have stalled the icemaker Follow

corrective measures described on

page 9. If water supply to the icemaker is not connected or not

turned on, make sure manual

icemaker switch is in the STOP position Code stops flashing when problem is corrected or SYSTEM CHECK- RESETpad is touched