Sears 8EAIRS Why the Red Warm, How the Electronic Alert, and Diagnostic System Works, Normal

How to Set the Door Alarm.

You don't have to set the visual

alarm° As long as either door is open, the red DOOR OPEN signal Light flashes,

If the signal bight on the

theDOORbeeperALARMalarmpadis setis glowing,. If it'snot, touch the pad to turn it on,

If either door is open far more than

30 seconds, a recurring beep sounds

DOOR OPEN

I! DOORON/OFFM 1

How the Electronic Alert

and Diagnostic System Works.

The word NORMAL is lighted

except when a failure has been detected

NORMAL

The SYSTEM CHECK-RESET	If	............
pad has two functions:		It
1. You can touch the SYSTEM		SYSTEM
CHECK-RESETpad and geta		CHECK Jl
review of the electronic diagnostic		il

The light goes out and the beeping stops when you close the door,

There are times when you'll want the Door Alarm beeper turned off. When you're rearranging a lot of food, for example_ Just touch the pad, The light will go out and the beeping will stop°

Deactivating the Door Alarm beeper does not turn the red DOOR OPEN light off-it keeps flashing until the door is closed

Why the Red Warm

Temperature Light Glows.

At first, it'sprobably because

your newly installed refrigerator WARM TEMP hasn'tcompletely cooled down

yet, Wait a few hours For it to cool, and then the light will go out

From then on, the red light will glow whenever temperatures inside get too high for proper food storage If this happens, open the doors only when absolutely necessary, and dose them as quickly as possible

As soon as inside temperatures return to normal, the light goes out

If the WARM TEMP light reappears and stays on for longer than 4 hours, call for service

codes in order of their priority° -il

2.You can touch the SYSTEM CHECK-RESET pad to erase three flashing codes immediately and two codes after the condition that caused them to flash has been corrected (see the next page),

lcontinued next page,_