SERVICE AND ADJUSTMENTS
TO LEVEL MOWER HOUSING (See Fig. 23 -
Fig. 26)
Adjust the mower while tractor is parked on level ground or driveway. Make sure tires are properly inflated (See "PRODUCT SPECIFICATIONS" on page 3). If tires are
over or under inflated, you will not properly adjust your mower.
NOTE: One rotation of trunnion nut is equivalent to ap- proximately 1/8 inch of height change. Be sure upper and lower nuts are tightened against trunnion after adjustment has been completed.
•Place mower height adjustment knob in position "3" (See Fig. 23).
•Lower mower lift lever to height adjustment knob.
•Measure distance from ground to lower flange of mower deck on both sides of mower (dim. "B°'& "C"). Dim. "B"
&"C" should be the same.
Level the mower
•To raise left side of mower, loosen upper trunnion nut tighten the lower trunnion nut.
•To lower left side of mower, loosen lower trunnion nut and tighten upper trunnion nut.
To obtain the best cutting results, the mower housing should be adjusted so the rear is approximately 1/4 to 3/8" higher than the front when the mower is in height adjust- ment position "3".
•Measure distance from ground line to lower flange of deck at right front and right rear (dim. "D" & "E") in line with front and rear tires.
Raise or lower rear of mower housing by adjusting the right rear lift link.
•To raise rear of mower housing, loosen upper trunnion nut and tighten lower trunnion nut.
•To lower rear of mower housing, loosen the lower trunnion nut and tighten upper trunnion nut.
•Recheck
MOWER UFT
LEVER
MOWER HEIGHT
ADJUSTMENT
KNOB
VIEWED FROM FRONT OF TRACTOR
RIGHT | LEFT |
SIDE | SIDE |
GROUND | UNE |
LOWER FLANGE | LEFT REAR |
OF MOWER DECK | UFT UNK |
FIG. 24
UPPER TRUNNION
REAR UFT UNK
TRUNNION
NUT
FIG. 25
REAR LIFT
UNK
LOWER FLANGE |
|
OF MOWER DECK | MOWER HOUSING |
FIG. 26
FIG. 23