JBL SDP-40 manual Pro Logic, Film & Music, Mode Adjust, Parameter, Note the following

SDP-40

MODE ADJUST

PRO LOGIC

MODE ADJUST @*PRO LOGIC

•Designed for playback of Dolby Surround-encoded sources.

•Decodes four channels from Dolby Surround-encoded sources.

•Uses a mono surround channel with a high-frequency rolloff above 7kHz.

•Available for comparison purposes, particularly with the

FILM, PLII MOVIE, and FILM listening modes.

Parameter

OUTPUT LEVELS	Refer to page 5-32
CUSTOM	Refer to page 5-33

Listening mode menu parameter descriptions begin on page 5-34.

FILM & MUSIC

MODE ADJUST FILM OR MUSIC

•Designed for playback of matrix-encoded digital stereo film or music sources.

•Derive six channels when both side and rear speakers are present (rear channels will be in parallel). Derives five channels when only side or rear speakers are present. The LFE channel, also referred to as the .1 channel, is generated through bass management in the SDP-40.

Parameter

OUTPUT LEVELS	Refer to page 5-32
CUSTOM	Refer to page 5-33

Listening mode menu parameter descriptions begin on page 5-34.

Note the following:

•The listening modes cannot be selected as the preferred listening mode for 2-channel sources. However, when the INPUT SETUP menu 2-CH parameter is set to USE LAST, the

SDP-40 will activate a listening mode if a listening mode was activated the last time a 2-channel source was present.

•The SDP-40 will not activate a listening mode unless a 44.1 or 48kHz PCM digital source is present. The listening modes are not compatible with 88.2 or 96kHz, Dolby Digital, or analog sources.

•The listening modes can be activated with the front panel or remote control Mode buttons. In addition, the FILM listening mode can be activated with the remote control dts button when a 2-channel source is present.

5-9